7
the tips of drilling bit and depth gauge corresponds with the required drilling depth. Tighten the
auxiliary handle by turning it anti-clockwise firmly in its desired position.
Inserting Tool Bits
The impact drill has a keyless chuck. Make sure that the drill or screw bit is not skew when it is
inserted and the chuck tightened.
Before inserting drill/screw bits open the jaws of the chuck.
Open the chuck until you can insert the tool bit. Insert the tool bit in the chuck and fasten the chuck
in clockwise by hand.
To remove the tool bit, please hold the machine and turn the chuck anticlockwise .Open the chuck
until you can remove the tool bit.
On/Off Switch
Use the On/Off switch to start the machine and keep holding it for continuous operation.
To switch the machine off, release the On/Off switch.
Locking button
The locking button can hold the switch on position for continuous drilling.
Please follow below step:
To lock the on/off switch, turn on the on/off switch and press the locking button, release the trigger.
The drill will continue to operate until the locking button is released.
To release the on/off switch, just press it again and then release it to stop.
Maximum speed control knob
The maximum speed control knob can adjust the running speed from low to high.
Please follow below step:
1. Switch on the tool
2. Lock the switch
3. Turn the knob clockwise to increase and anti-clockwise to reduce the maximum speed.
Forward/reverse switch
Important!
The machine has to come to a complete stop before the forward/reverse switch
can be used;
otherwise the machine may be damaged.
Use the forward/reverse switch to switch between clockwise and anticlockwise rotation.
Hammer/drill switch
Important!
The machine has to come to a complete stop before the hammer/drill switch can be used;
otherwise the machine may be damaged.
The hammer/drill switch can switch the drill and hammer/ drill functions.
Select to the hammer icon side to operate as hammer drill. And select the drill icon side to operate
as drilling operation.
When drilling into Concrete, it is recommended to use the hammer drill operation.
Don’t use the hammer drill function for ceramic tile or others material can’t withstand impact
energy.
When drilling into metal and wood, it is recommended to use the drill operation only
Tight
Loosen
Summary of Contents for SCID133106D/994058
Page 10: ......
