Prelude
Please read carefully before using the device!
This manual should help you:
- to use the product properly
- to avoid damage
- to increase durability and reliability
- to prevent -a hazard
Attention!
go-e GmbH does not assume any liability for damages caused by
disregarding these instructions!
Page 6
Warnings
Failure to comply with the operating instructions can have serious
consequences. go-e GmbH does not accept any liability for damage caused
by disregarding the operating instructions or other warnings on the device
itself.
Attention!
High voltage, fire hazard!
Never use the device if the housing is damaged or opened!
Do not use the go-eCharger if the cables attached or connected to the unit
are damaged.
Never use wet or dirty plugs in conjunction with the go-eCharger.
Make sure that the connection to which the go-eCharger is to be connected
has been properly installed and is undamaged.
The circuit to which the go-eCharger is to be connected must be fitted with a
residual current circuit breaker and a circuit breaker.
Any changes or repairs to hardware or software may only be carried out by
qualified personnel of go-e GmbH or specially trained personnel.
Removal of any warnings on the go-eCharger will result in the loss of any
liability by go-e GmbH.
The go-eCharger may only be used for the purpose of charging EV batteries
in conjunction with appropriate adapters and cables.
It is important to observe the maximum permissible charging current at the
connection at which you are charging. If this is not known, charge with the
lowest charge current. When using adapters, the maximum current for the
adapter must be observed. If this is not known, use the lowest charging
current
ATTENTION: An automatic reduction of the charging current to 16A by
connecting the adapter is only possible in combination with the original go-e
adapters.
Never use adapters whose technical suitability is unclear!
Never unplug the plug from the connector on the cable!
When used with safety sockets, we recommend a maximum charging current
of 10A.
Take care of a mechanical relief of the Schuko plug by supporting the weight
of the go-eCharger and the connected charging cable!
Observe the specifications of the grid operator with regard to single-phase
Page 7
!
Attention
!
Attention
Summary of Contents for go-eCharger
Page 1: ......
