12
Flexible hoses should not pass through bulkheads, decks or partitions unless protected from
abrasion. Flexible hoses should not be subjected to temperatures above 50°C
After installation the appliance must be tested for gas soundness.
In the event of problems being encountered during installation, commissioning or operation the
manufacturer should be informed and any necessary service arranged. Unauthorised servicing
will invalidate the manufacturers warranty.
Gas connection (Recreational Vehicles, Caravans)
The Cooker is fitted with a ½” Tapered Female BSP iron at the rear of the appliance.
When installing the cookers in caravans/recreational vehicles the gas system installation must be
carried out in line with the requirements as laid down in BS EN1949:2002:
- If more than one appliance is fitted in the caravan and gas is supplied via one single line, there
must be individual shut-of valves for each appliance and the user must be able to identify the shut-
off valves and their open and close positions. - (as set out in Clause 8.8)
- Pipes conveying gas shall not be used as an earth electrode or earth continuity conductor.
Bonding to the earth continuity conductor is required.
– (as set out in Clause 8.9)
- For caravan installation a metallic connection to the cooker is required. Appliances shall be
connected to the supply by metallic piping which shall be rigid and free of stress. (
– as set out in
Clause 9.1)
Before first use
Remove all accessories and packing from within the oven and before the first use, clean the
interior and all fittings with a soap and warm water solution.
Important When using the grill for the first time, or when re-connecting after the gas supply has
run out, you will need to prime the grill burner. To do this set the control knob to grill setting and
hold in the knob for 10 seconds. Continue to hold in the knob and ignite the grill using a match
or lighter, moving the flame in a circular motion until the grill is fully ignited. Release knob and
leave grill to run for a 1-2 minutes. The grill can then be lit using the ignition button.
To burn off lubricants used in manufacturing heat the oven to 200°C and leave for 30 minutes
before introducing the initial batch of food to be cooked.
Spare parts
Please contact us if you have a technical problem or need a spare part.
When you report a problem try to describe the nature of the fault.
Always give your appliance's full name, model and serial number.
Make a note of this information in this space:
Name:
Model Number:
Serial Number:
