B36
18
Programming the described shape:
a)
Press P3 button for once for the 1st angle,
b)
Press P2 button three times successively for 90° bending in 2nd, 3rd and 4th angles.
c)
The programming process for the 5th angle made after pressing P3 button is saved to the memory by
pressing the foot pedal and programming process is completed. After the setting procedure is
completed
(Figures 13a-13b-13c-13d-13e-13f-13h-13h)
bending order is followed and Stirrup
Bending should be completed.
NOTE:
When the program ON-OFF SWITCH BUTTON is turned to ON position program is
reset and it must be re-programmed. The button should be switched to OFF position as long as it is not
needed. In case it is turned, the program should be redone as it is shown in the example.
NOTE:
Iron that will be stirred up should be bent on an appropriate Bending Sleeve, Pin, Stir-up
pin or straight pin with at least 5 times bigger than the bending iron's diameter.
(13a)
(13b)
(13h)
