25
Preparation
Remove all parts from the carton and place them on a clean, soft and dry surface. Check the parts list to make sure nothing
is missing. Properly dispose of packing materials. Please recycle whenever possible.
Components
Fireplace
A-Wall support 1pcs
B-Wall bracket 1pcs
C-Phillips
screws(ST4.2x40) 7pcs
D-flat head screw
(Ø6x35) 7pcs
E-Remote control
F-Phillips
Screws
(ST3.5x8) 2pcs
Operation
Read and understand this entire user manual, including all safety information, before connecting or using
this product. Failure to do so could result in electric shock, fire, serious injury or death.
Your appliance is a wall-mounted, recessed and /or mantel installed appliance. Select a suitable location that is not
susceptible to moisture and is away from drapes, furniture and high traffic areas.
Please confirm the power is off when you start to installation.
Plug in the unit into the power, the power should be no less than 10Amp/230V AC. If the power cord is not long enough,
you can use an extension cord that the power is no less than 2000W. A 10AMP, 230V circuit is required to operate this
appliance. Dedicated circuit is preferred but not essential in all cases, a dedicated circuit will be required if, after
installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating. Additional
appliance on the same circuit may exceed the current rating of the circuit break.
NOTE
When the heater is turned on for the first time, there may be a slight odor. This is normal and should
not be repeated unless the heater is used for a long period of time.
NOTE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons
too quickly. Give the unit time to respond to each command.
