XRS-330C
25
SELECTING PRIORITY SCAN
To select Priority Scan, refer to the Menu/Scan Settings options.
To begin scanning:
Briefly press
SCAN
. A high beep will be heard, ‘SCANNING’ will be displayed and
the
icon will animate. During this time the scan mode and the number of
channels being scanned will be displayed along with the selected Zone.
•
If a signal appears on the Priority channel - at any time - the radio will
switch directly to the Priority channel and will stay there for as long as
the channel remains busy. During this time you can transmit and receive
on the Priority channel.
Once the Priority channel has been clear for 5 seconds the radio will resume
scanning the other channels.
•
If a signal appears on any other channel, scanning will pause on that
channel and will remain there while the channel is busy - as long as
there are no signals on the Priority channel.
During this time, the receiver will continue to check the Priority channel every 2
seconds resulting in a series of small breaks in the reception. Once the signal has
gone and there has been no activity for 5 seconds, the radio will resume scanning.
•
If the radio is paused on a busy channel and you want to remain there,
briefly press
SCAN
. The radio will exit scan and remain on the busy
channel. At this point you will no longer be monitoring the Priority
channel.
To resume the Priority Scan, press
SCAN
again.
•
If you don’t wish to listen to a busy channel, briefly press the
or
key while the radio is paused on that channel. The busy channel will be
temporarily removed from the Scan Group to allow time for the channel
