MK00
1W INS
TALL
A
TION - CUTTIN
G TEMPL
A
TE
66 mm
8 mm
2.5 mm
165 mm
10 mm Drill Bit
Mounting
Screw Clearance
8 mm Drill Bit
Mark and cut a hole 66 mm (h) by 165 mm (w),
allowing for clearance of the two mounting screws holding the radio to the surround.
Use a 10 mm drill bit to form the radius of the corners and an 8 mm drill bit
for the clearance of the mounting screws
.
1.
Select
a
convenient
location
in
the
dashboard
or
bulkhead.
Minimum area required is 96 mm (h) by
212
mm
(w).
Mak
e
sure
there
is
sufficient
space
behind to accommodate the body and leads without fouling any electrical wiring or control cables etc.
2.
Use template (see overleaf) to mark,
drill and cut
the hole
.
3.
Place the MK001W in the cut out and mark the four outer screw holes
. Remove and drill each hole using
a 3 mm drill bit.
4.
Install
the
radio
in
the
MK001W
using
the
two
machine screws (supplied) by engaging them in the threaded holes in each side of the r
adio housing.
5.
Connect the antenna lead,
DC power lead and
extension
speak
er
leads
(if
fitted)
as
per
the
radio’
s
instructions and check the r
adio is oper
ational.
6.
Insert combined r
adio and MK001W and secure with
four
self
tapping
screws
(supplied).
If
the
radio
is
mounted in an exposed position it may be advisable to run a bead of suitable sealant
behind the surround
to prevent w
ater seeping behind the dash board
or bulkhead.
7.
Install dress caps (supplied) over the self tapping screws to neaten the installation.
NB If you are replacing a GX548
VHF r
adio flush
mounted in the MK548 the size of the cut out may have to be enlarged slightly
, mounting holes will still align.
