GMC VEC156-AU, Instruction Manual

Page: 9 / 16

9
Unpacking
Due to modern mass production techniques, it is unlikely that
your GMC Power Tool is faulty or that a part is missing. If you
find anything wrong, do not operate the tool until the parts have
been replaced or the fault has been rectified. Failure to do so
could result in serious personal injury.
Operation
It is recommended that for first time charging, you charge your
spotlight using the AC power adaptor.
Important. For first time operation of spotlight, the average
charge time is 12-15 hours.
Charge time after first use is 12-15 hours.
If unit is not used for two months, it is suggested the battery be
recharged for approx 4 hours and repeated every 2 months of
non use.
Important. Do not charge with AC and DC chargers at the
same time.
AC power charging
CAUTION. Use only with AC Charging Adapters that are
approved with unit.
Important.
Before plugging in the power supply from the
charger to the spotlight always ensure that the plug is switched
off at the main as well as the spotlight and trigger switch is in the
off position.
1. Connect the power supply from
the charger to the spotlight via
the barrel connecter. Plug into
the recharge port socket located
in front of the trigger switch (5).
2. Plug in the charger and
switch on. The LED indicator
(6) will show power and
that charging is taking place.
3. Charge for approximately
12-15 hours maximum
or until the green LED is lit.
4. Turn off the charger power supply from the main. Disconnect
the barrel connecter from the recharge port (5). Wait 5
minutes before use. Store adaptor in a safe place.
Do not overcharge – Charge until LED light green status (max
15 hours).
Important.
Do not operate when charging.
DC power charging
CAUTION.
Use only with DC Charging Adapters that are
approved with unit.
Important. The DC source (jump starter, battery pack, vehicle
accessory socket, etc.) must be 12 Volt DC and should be able
to supply at least one half Amp at 12 VDC for 10 hours.
Important. Before you begin charging, ensure that the spotlight
trigger switch (1) is in the off position.
1. Plug the DC fused recharge adapter (10) into the recharge
port located in front of the trigger switch (5).
2. Insert the power plug into the accessory socket of your power
source. The LED indicator (6) will show power and that
charging is taking place.
3. Charge for approximately 15 hours max or until the green
LED is lit.
4. Disconnect charger from power supply. Unplug the barrel
connecter from the recharge port (5) Wait 5 minutes before
use. Store adaptor in a safe place.
Do not overcharge – Charge
until LED light green status.
DO NOT charge for more than
15 hours with DC charger.
NOTE. Some vehicles must
have the ignition switch
on to power the vehicle
accessory outlet.