To scan stations, press and hold the SEEK up or down
arrow for two seconds until you hear a beep. The radio
will go to a station, play for a few seconds, then go
on to the next station. Press either SEEK arrow again to
stop scanning.
To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear
two beeps and PSCAN will appear on the display, along
with the highlighted preset. The radio will go to one of
the preset stations, play for a few seconds, then go on to
the next preset station. Press either SEEK arrow
again to stop scanning presets.
The radio will only seek and scan stations with a strong
signal that are in the selected band
Setting Preset Stations
Up to 30 stations, six AM, six FM1, six FM2, six XM1,
and six XM2, if equipped, can be programmed using the
six screen buttons on the bottom of each band menu.
To set preset stations, do the following:
1. Turn the audio system on.
2. Press the BAND hard key to select AM, FM1, FM2,
XM1, or XM2, if equipped.
3. Tune to the desired station using the SEEK hard
key or the tuning knob.
4. Press and hold one of the six preset screen buttons
until you hear a beep. Whenever that preset
screen button is pressed, the station that was set
will return.
5. Repeat the steps for each preset and source.
3-3
Summary of Contents for 2006 Yukon XL
Page 4: ...Overview Navigation System Overview 1 2...
Page 50: ...NOTES 2 38...
