1) Red LED flashes once ( Motor type setting available )
2) Red LED flashes twice ( Battery type setting available )
……
18) Red LED flashes 18 times (Maximum Brake Amount setting available )
19) Red LED flashes 19 times ( Factory setting available )
At the selected program function to be changed, if the throttle stick is stayed at the full power position for
over 4 seconds, the red and green LED should flash to indicate that you can now change an existing
parameter to a new parameter. In order to change the existing parameter, move the stick to the minimum
or lower position then again to the full power position. The selected parameter will indicate as follows.
Sensorless Sensored
Brushed
Defalut
1 Motor Type
Brushless Sensorless(1) / Brushless Sensored(2) / Brushed(3)
Sensored
2 Battery Type
LiPo(1) / LiFe(2) / NiMh (NiCd) (3)
LiMh
3 Cut Off Voltage
Auto(1) / 3.0V(2) ~ 5.5V(0.1V Step)
Auto
4 Power Curve
Soft (1) / Linear(2) / Hard(3)
Linear
5Advance Timing
0`(1) ~ 25`(6) / 0(1) ~ 10(6)
25’ / 10
6 Acceleration
Lowest(1) / Low / Normal / High / Highest(5)
Highest
7 Start Power
Lowest(1) / Low / Normal / High / Highest(5)
Highest
8 Start Current Limit
Off(1), 10% (2) ~ 100% (11)
Off
9 Current Limit
Off(1), 11% (2) ~ 100% (11)
Off
10 Reverse Function
One Way(1) / Two Way1(2) / Two Way2(3)
Two Way 2
11 Reverse Delay
0.2s(1) / 0.5s / 0.8s / 1.3s / 1.8s / 2.5s (6)
2.5s
12 M-Reverse Amount
20%(1) ~ 100% (9)
60%
13 Neutral Width
Narrow(1) / Normal(2) / Wide(3)
Normal
14 Speed Mixing Brake
0%(1) ~ 100%(11)
0%
15 A.B.S Brake
Off(1) / Weakest / Weak / Normal / Strong / Strongest(6)
Off
16 Auto Brk Amount
0 % (1) ~ 100% (11)
0%
17 Min Brake Amount
0 % (1) ~ 100% (11)
30%
18 Max Brake Amount
0 % (1) ~ 100% (11)
100%
19 Factory Setting
All parameters to be initialized as factory default values (2)
z
The inside number of the brackets above is the number of the LED flashing.
z
The cutoff voltage in automatic mode is as like:
-
LiPo : the higher voltage between 5.5V and 66% voltage when the switch is on
-
LiFe : the higher voltage between 5.0V and 67% voltage when the switch is on.
-
NiMh/ NiCd : the higher voltage between 4.0V and 50%voltage when the switch is on.
After you select your wanted parameter, stay the throttle stick at the neutral position for over 4 seconds,
the red LED should flash and the motor should beep (Mi, Re, Do, Re, Mi sound) to indicate that the
selected parameter is stored at the ESC and other parameters can be selected.
