GLP impression s350, User Manual

Page: 19 / 44

German Light Products®
GLP® impression S350 User Manual 19
Figure 8 Mounting points in base
5. Preparation for use
Warning! Read ‘Safety’ starting on page 4 for important safety information
that you must understand before you install or operate the fixture.
Included Items
The impression S350 is supplied with a power cable with a powerCON TRUE1 connector
and a tripod with Camlock fasteners for use as a floor stand.
Orientation and location
The impression S350 may be rigged in any orientation following the instructions in this
chapter or placed on a level surface in locations where it is safe to stand the fixture.
Keep the head at least 0.2 m (8 in.) away from combustible materials (including
curtains and stage scenery) when the fixture is installed.
Make sure that there is no risk of collision when the head pans and tilts. Allow a
minimum center-to-center distance of 600 mm (23.6 in.) when installing impression S350
fixtures side by side.
Mounting fasteners in base
See Figure 8. The base of the impression S350 has two threaded holes A that accept
M10 bolts or screws, and four mounting points B that accept standard camlock
quarter-turn fasteners. The camlock center-to-center distance is 90 mm (3.54 in.).
A
B
B
B
B
A