www.glp.de
Connecting
to DMX data
20
EXO Spot 30 User Manual Rev. A
6.
Connecting to DMX data
Check that all cables and connectors are suitable for the installation environment and
application (see recommendations in ‘Avoiding damage to the fixture’ on page 10).
Use digital 110 Ohm DMX cable with IP65 5-pin XLR connectors to supply DMX data to
fixtures.
Keep connectors sealed with their rubber caps at all times when not in use.
The EXO Spot 30 has two 5-pin XLR sockets for IN and THRU connections to a DMX data
link.
EXO Spot 30 fixtures support the USITT DMX 512A signal protocol. They also support
RDM (Remote Device Management).
The 5-pin XLR connectors use standard pin allocations:
1 Signal Ground
2 Data –
3 Data +
4 Not used
5 Not used
The DMX cable should start at the console and be daisy-chained through each fixture
to be controlled using the DMX input and DMX link out connectors. If you need to split
the DMX cable, use a powered DMX splitter.
If you would like advice with planning and installing a DMX link, your GLP supplier will
be happy to provide assistance.
Summary of Contents for Fusion EXO Spot 30
Page 1: ...Fusion EXO Spot 30 User Manual Software version V1 0 00...
Page 42: ......
Page 43: ......
