Glomex PANDORA V8001, User And Installation Manual

Page: 62 / 172

URANIA 2 V9331 - PANDORA V8001 - RHEA V8100
60
ENGLISH
www.glomex.it
9. MAINTENANCE
9.1 PREVENTIVE MAINTENANCE
GLOMEX antennas PANDORA V8000 and URA-
NIA 2 V9330 require minimum preventive mainte-
nance.
Observing the following instructions is sufficient to
maintain a high equipment performance.
Monthly checks
- Wash the radome surface with a cloth damped
with fresh water; do not direct pressurized water
jets onto the radome.
S
WARNING
Do not use brushes, abrasive products, detergents
or alcohol-based liquids.
Yearly checks
- Check the outer conditions of the radome. Clean
from dust and dirt if necessary.
Checks before any long cruise
- Check that the antenna is correctly fastened.
S
DANGER
Before carrying out any maintenance or cleaning
operation, or after each use, ALWAYS turn off the
antenna by means of the switch located on the
control unit or from the on-board control panel.
9.2 SPARE PARTS
The following table lists the codes of the compo-
nents which can be supplied as spare parts directly
by the Retailer.
Should you have problems with the operation or in
case you need technical support, first of all contact
the authorized Retailer. Keep at hand the serial
number of your antenna (on page 2 in this manual)
and a list with the failure symptoms. Should no
Retailer be available, contact the GLOMEX Service
Centre (see section “Technical Support”).
S
WARNING
You will be asked the serial number of your
antenna during any service or troubleshooting
phone call. The serial number is found on page 2 of
the user manual of your antenna (see page 39 for
serial number indications).
S
WARNING
Conserve the installation and user manual with
care, as it contains the serial number of your
antenna!
Component GLOMEX code
Lower radome V9331 V9331-LR
Upper radome V9331 V9331-UR
Lower radome V8001 V8001-LR
Upper radome V8001 V8001-UR
Lower radome V8100 V8100-LR
Upper radome V8100 V8100-UR
Fuse for control unit T3A15 5x20 4.120.0076