Glomex PANDORA V8001, User And Installation Manual

Page: 49 / 172

URANIA 2 V9331 - PANDORA V8001 - RHEA V8100
47
ENGLISH
www.glomex.it
7. Position the antenna onto the seal, and firstly
insert the cable through the relevant hole, then
the 4 screws, and pay attention to direct the ori-
entation symbol of the antenna towards the
bow.
8. Install the fastening reinforcements onto the
threaded bars and screw in the M8 self-locking
nuts.
9. Completely tighten.
S
WARNING
GLOMEX declines any liability for an incorrect
mounting of the radome on the boat.
10. Connect the 10 m coaxial cable to the cable
coming out of the antenna.
Should it be necessary to shorten the cable,
please refer to the instructions given in Fig. 11.
S
WARNING
Do not pull nor damage the cable coming out of the
antenna! It is not provided with an outer sheath as
the 10 m coaxial cable!
11. Make sure that the cable core is correctly
inserted in the central hole of the female con-
nector on the antenna (otherwise, there could
be a short circuit and the fuse installed on the
power supply line inside the control unit would
trip).
Manually screw in the ring nut of connector F.
Once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench.
NOTE: For the connection of the antenna coaxial
cable, it is not necessary to remove the upper
radome!
Fig. 9
Fig. 10
GL00095
Fig. 11