REV. 03.09.04
Notes on program execution and modification
Visualize parameters of program execution
During execution, the name of a program is shown on the top of the display. In addition, the
display shows the body parts where the program can be used (BODY means that it can be
used on any muscular district), the total number of phases, the phase in progress (full phase),
the remaining time of the phase in progress, and the kind of current being employed (e.g. EMS,
TENS). For programs with intermittent stimulation, the display shows the countdown (in the cen-
ter) and a graphic representation of the phase of work or rest.
Pause a program
To pause a program, press the OK key; the word PAUSE appears on the display. Pausing sets
the intensity to zero and stops the clock. To restart to the program, press OK. Resumption after
a pause repeats the last interrupted cycle.
Stop a program
If you need to stop a program before its end, switch off the instrument by pressing the OK key
for 3 seconds.
Visualize total time remaining (single program)
During execution of a program, the remaining time of the current phase in progress is displa-
yed. To visualize the total remaining time, press the TIME key. During visualization of the total
remaining time, all indicators of the phases are lit. After 2 s, the remaining time of the phase in
progress appears again.
Skip a phase (single program)
In order to pass to a successive phase before the end of the one in progress, press the RIGHT
key for 3 seconds. To return to the previous phase, press the BACK key for 3 seconds.
Increase or decrease intensity
To change the intensity of a single channel, use the corresponding INCREASE or DECREASE
INTENSITY key. To simultaneously increase or decrease the intensity of all channels, use the UP
or DOWN key.
13
