Basic connection
After purchasing receiver, unpack it and check
to make sure that all of the following items are
included in the packaging:
•
Receiver
•
Remote controller
•
Quick Start manual
•
Batteries - 2x AAA (optional)
To install the batteries in the remote control,
remove the flap protecting the battery
compartment If inside the chamber there are
used batteries, they must be removed. Then
put new batteries inside. When installing the
battery, pay special attention on the polarity -
the direction of insertion of both batteries. The
correct polarity of batteries is drawn on a
description inside the battery compartment in
the remote control. After installing the
batteries, place protecting flap on its original
position.
Next, connect cable from LNB/ANTENNA (1 on
picture) to receiver’s (3) SAT IN connector.
Using HDMI or SCART cable (4) connect
receiver with TV Set (2). Finally, at the end
connect main cord (5) to main socket.
Turn on the TV Set. After while on TV Set
screen You should see receiver’s OSD. If TV Set
not display receiver’s OSD, probably signal
source is set wrong in TV. Check TV Set
documentation for information how to change
signal source.
Operating notes
Working with external USB drive
During the selection and operation with USB drive (hard drive, flash memory), user should pay attention on:
•
Drive is compliant with USB 2.0 and have the appropriate parameters of read and write speed,
•
Drive contain single partition, formatted in a supported format,
•
If necessary (especially for USB hard drives, which are characterized by a high power consumption), drive should
be supplied from an external power supply,
•
Do not disconnect during a write/read data operation,
•
Do not use very full or fragmented drive,
Mismatch above recommendations may result in incorrect operation of the devices and in extreme cases can cause
damage.
The manufacturer takes no responsibility for any damages directly or indirectly caused by loss of recorded or edited
data stored on an external USB drive which was connected to the receiver, and gives no warranty for any other data
on the USB drive when case of abnormal function receiver will happened.
