15
DiSEqC1.2
a. Move Continuously
Press LEFT/RIGHT button on this item, you
can continuously drive the motor to West
(LEFT) or East (RIGHT). It will stop under
three circumstances: it found signal strong
enough, it meets the limitation you set (see
“Set Limit” for more details), or you release
the LEFT/RIGHT button. If it found signal
and stop, you can adjust the position by
drive the motor step by step (see “Move
Step” for more details) to get best signal
and then store the best position (see “Store
Position” for more details).
b. Move Step
Press LEFT/RIGHT button on this item, you
can drive the motor to West (LEFT) or East
(RIGHT) step by step ( the step is set to 1
by default ).
c. Store Position
Press OK button on this item to store the
current position of the motor for the selected
satellite.
d. Set Limit
Press LEFT/RIGHT button to change
function to “West”(set west limitation),
“East”(set east limitation) or
“Disable”(remove all limitations).
Press OK button to execute the setting.
e. Goto Reference
Press OK button to drive the motor going to
reference position.
After you install your motorized DiSEqC
system well and got signal strong enough,
press RED button to scan it.
USALS
USALS is very convenient motorized DiSEqC
system that supports DiSEqC1.3 command
and also can get the satellite position
automatically if you know your geographical
location. Basically, the listed satellites have its
Longitude and therefore the angle of the
satellite can be calculated without problem. If
you have USALS motorized system, then you
can use the USALS as followings.
a. My Longitude
It means the longitude of your location. You
can set the angle “East” or “West” will be
selected by LEFT/RIGHT button.
b. My Latitude
It means the latitude of your location. You
can set the angle by 0-9 buttons, “South” or
“North” will be selected by LEFT/RIGHT
button.
c. Goto Reference
Press OK button to go to the reference
position.
d. Move
Press OK button to drive the motor to the
exact position corresponding to the satellite
position you are entered.
e. Store
Press OK button to store current position of
the motor for the selected satellite
-
Power: Press OK or LEFT/RIGHT button to
set LNB power as OFF, 13, 18, 13/18, 14,
19, 14/19.
Transponder
