Page 19
Maintenance Mode
Maintenace Mode is made up of four sub menu displays, Setup Parameters, Diagnostics, System Counters and
Information. Refer to the table below for the options and actions of each available menu display.
Entering Maintenance Mode
Two options are available for entering the maintenace mode.
Option One:
1. Unplug the slicer.
2. While holding down the STOP button, plug in the slicer. During start up the display will show “Entering
Maintenance Mode.”
Note: Once Maintenance Mode has been entered, use the STOP button to navigate through selections
and the START button to select the option.
Option Two:
1. Remove the knife cover.
Note:
When knife cover is removed, the knife motor will not start and display will show “ATTENTION Knife
Cover Removed Install Knife Cover.”
2. Hold down the STOP button. An “*” in the top left corner of the display screen will appear. Release the STOP
button when the “*” disappears from the display.
3. When the Globe logo appears, press and hold the STOP button. The display will show “Entering Maintenance
Mode.”
4. Repeat steps 1-3 if display does not show the “Entering Maintenance Mode” screen.
Note: Once Maintenance Mode has been entered, use the STOP button to navigate through selections
and the START button to select the option.
