Page 10
Page 7
Disc Installation
CUBING/DICING DISCS
IMPORTANT:
• When using the cubing/dicing discs always be sure to use the knife with the matching sized grid or disc.
Check the number imprinted on the knife and back of the grid or disc for proper match.
• The WK grids only work with the WKB body. The WKB body has a
WK imprinted on the bottom of the disc.
• GVC600 - Make sure the cubing/dicing frame is in the disc body
correctly. The tab on the frame should lie against the rim of the disc
(Fig. 10-1).
1. Carefully hold the grid or disc (palm up) with sharp blades up.
2. Place the grid or disc on the drive shaft.
3. GVC600 only - Turn the disc until it falls into a locked position and the grid portion lines up with the opening in
the hopper head (Fig. 10-2).
The cubing/dicing knife is extremely sharp. ALWAYS handle the knife by the thick side only,
keeping fingers away from the cutting edge.
4. Carefully place the cubing/dicing knife with hub down onto the drive shaft (Fig. 10-3).
5. Carefully turn the knife until the drive pins line up with the slots on the knife hub and the knife is securely on
the drive shaft (Fig. 10-4).
Fig. 10-1
Fig. 10-2
Fig. 10-3
Fig. 10-4
GFP500 and GVC550
GVC600
SHARP KNIFE BLADE
TO AVOID SERIOUS PERSONAL INJURY:
• NEVER
put your hand in the food hopper with the on/off latch in the ON position.
• ALWAYS
turn the vegetable cutter off and unplug the unit before cleaning or servicing.
• DO NOT
immerse the unit in water.
• ALWAYS
keep fingers away from sharp knife edges and handle discs with extreme care. Cutting edges of
the discs are extremely sharp.
• DO NOT
leave discs in soapy water. Always clean the cutting discs immediately after each use. Handle the
cubing/dicing knife with extreme care!
• DO NOT
carry the unit by holding the ejection chute or food pusher handle.
• ALWAYS
carry the unit with both hands underneath the unit.
• ALWAYS
use the food pusher or plastic pusher to feed product.
OPERATING THE VEGETABLE CUTTER
1. Unplug the vegetable cutter.
2. Lift the on/off latch upward to the OFF position and raise the hopper head to the left
so it rests in the open position (Fig. 7-1).
3. Place the ejector plate onto the drive shaft. Turn the plate until the hole is properly
aligned with the alignment pin on the drive shaft (Fig. 7-2). The plate should be nearly
flat against the housing.
4. Select appropriate cutting disc and install it onto the drive shaft (see disc installation
section on pages 9 and 10 for instructions).
5. Lower the hopper head to its closed position. Do not push down on the on/off latch
at this time.
NOTE:
The hopper head will not close if the disc is not installed correctly.
DO NOT
use force. If the hopper head does not close properly, make sure the vegetable
cutter is unplugged and reinstall the disc.
Operating Instructions
Fig. 7-1
Fig. 7-2
