Globalstar STX3, User Manual

Page: 11 / 32

99
COMMAND SYNTAX DESCRIPTION
Help
? Display a list of the available commands with brief descriptions.
Send Data
data <payload>
Uses the serial packet command format to send a command using the 0x00
command ID. The payload is expected to be up to 144 bytes of hex values
encoded in ASCII.
Get ESN esn
Uses the serial packet command format to send command 0x01 to return the
device electronic serial number.
Abort
Transmission
abort
Uses the serial command format to send command 0x03 to abort the current
message transmit sequence.
Query Bursts bursts
Uses the serial command format to send command 0x04 to return the current
number of burst remaining.
Query FW Version firmware
Uses the serial command format to send command 0x05 to return the STX3
current firmware version.
Setup
setup <channel,
bursts, interval_min,
interval_max>
Uses the serial command format to send command 0x06 to setup the device.
The parameters are comma separated and are entered in the decimal format.
• channel – The RF Channel
• bursts – The number of bursts
• interval_min – The minimum burst interval
• interval_max – The maximum burst interval
If no arguments are used, then command 0x07 is issued to query the current
setup state.
Query HW Version hardware
Uses the serial command format to send the command 0x09 to return the STX3
hardware version.
CW Test Mode
test_cw
Uses the serial command format to send the command 0xFC01 to enter the CW
test mode for 30 seconds.
Send Test Packet test_packet
Uses the serial command format to send the command 0xFC02 to send the
0x80AAFOFOFOAAFOFOFO test packet.
Modulation Test
Mode
test_modulation
Uses the serial command format to send the command 0xFC03 to send back to
back test packets for 30 seconds.
Direct AT
Command
<AT Command>
AT commands are supported at any time. The user types the AT command as
specified in the STX3 User Manual.
Temperature
temperature Checks the temperature using the Si7020 sensor and displays the value.
Humidity humidity Checks the humidity using the Si7020 and displays the value
Accelerometer accel
Checks the current x, y, and z values of the LIS2DH12 accelerometer and
displays the value
The following table provides a description of the serial commands.