12
Command
Description
enabled, the server will optimize the data rate and the
transmission power of the module based on the
information collected from the network.
AAT2 ADR=?
Response:
0: disable
1: enable
This command will return the state of the adaptive data
rate mechanism.
AAT1
EVK_TxCycle=[parameter1]
[parameter1]: decimal number representing the report
interval in seconds, from 1 to 254.
This command will only take effect when “TestMode”=1.
Response:
ok
if parameter1 is valid
invalid_param
if parameter1 is not valid
This command sets the report interval for the module.
AAT1 EVK_TxCycle=?
Response: decimal number representing the interval, in
seconds, for EVK_TxCycle, from 1 to 254.
This command will return the interval, in seconds, for EVK_TxCycle.
AAT2
JoinMode=[parameter1]
[parameter1]:
0: ABP mode
1: OTAA mode
Response:
ok
if address is valid
invalid_param
if parameter1 is not valid
This command informs the
module activation type.
AAT2 JoinMode=?
Response:
0: ABP mode
1: OTAA mode
This command will return the
activation type
of module.
