9
Command
Description
This command sets the state of the active report mode
for the module.
AAT1 TestMode=?
Response:
0: disable (Active Report Mode: Off)
1: enable (Active Report Mode: On)
This command will return the state of the active
report mode.
AAT2
DevAddr=[parameter1]
[parameter1]: 4-byte hexadecimal number representing the
device address, from 00000001
– FFFFFFFF.
Response:
ok
if address is valid
invalid_param
if parameter1 is not valid
This command configures the module with a 4-byte unique
network device address [parameter1]. The [parameter1]
must be unique to the current network. This must be
directly set solely for activation by personalization devices.
This parameter must not be set before attempting to join
using over-the-air activation because it will be overwritten
once the join process is over.
AAT2 DevAddr=?
Response: 4-byte hexadecimal number representing the
device address, from 00000001 to FFFFFFFF.
This command will return present end-device address of
the module.
AAT2 DevEui=[parameter1]
[parameter1]: 8-byte hexadecimal number representing the
device EUI.
Response:
ok
if address is valid
invalid_param
if parameter1 is not valid
This command sets the globally unique device identifier for
the module. The identifier must be set by the host MCU.
The module contains a pre-programmed unique EUI and