Instruction Manual
2
INSTALLATION INSTRUCTIONS
RISK OF ELECTRIC SHOCK. READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL THIS LIGHT.
DISCONNECT MAIN POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING THE FIXTURE.
1
3
4
7
5
6
2
Cable
Note: Up to 4 lights can be linked together.
Install additional fixtures by following the same instructions as above.
Use the power cord to link two fixtures together, (see illustration above).
WARNING
48” LED SHOP LIGHT - DOUBLE TUBES, 40W
Using a 6mm drill bit, drill two holes in the desired
mounting surface area. Note: Ensure mounting surface
is adequate to support the weight of the light.
Using a hammer, tap the (2) 6mm wall anchors (provided)
into the drilled holes.
Insert and twist the (2) 3.9mm hooks (provided) into the
wall anchors until completely tight.
If mounting onto a solid hardwood surface, skip to step 3.
If mounting onto a solid hardwood surface, twist hooks
directly into the surface (anchors are not required).
Slide the hanging cables through the holes on each end of
the fixture, as seen in the illustration above.
If metal pull string is too high to reach, attach 3-ft. pullcord
extension (included).
Hang the fixture by looping the (2) cables around the
mounting hooks. Plug in power cord, and ensure the light
turns on. The fixture is now installed.