2
Electrostatic Sprayer
PRODUCT HIGHLIGHTS:
Fine Atomization
The diameter of the nozzle of the electrostatic
sprayer is relatively thin, and the mist sprayed is
4 times thinner than an conventional sprayer.
User can cover the same square footage while
using a fraction of the solution.
Electrostatic Disinfection
The electrostatic sprayer uses specialized
solution that is combined with air and atomized
by an electrode inside the sprayer. The spray
contains positively charged particles that adhere
to all surfaces and objects. The particles in the
spray are positively charged, so they are able to
cling and coat any surface they’re aimed at.
High Efficiency
The electrostatic spray clings to objects and
doesn’t easily run. The spray will form a film on
a surface and coat all sides of an object; there is
no need to go over the same area twice. This
not only saves on the amount of solution being
used, but also improves the spray efficiency and
rate.
OPERATION:
Installation
1) Insert o-ring and gasket into the groove of the
handle switch port of the sprayer.
2) Connect the wand to the sprayer handle.
3) Select the appropriate nozzle and attach it to
the end of the wand.
Note:
Always tighten and inspect nozzles.
Test Sprayer
1) Turn and open the solution tank cap on the
top of the sprayer.
2) Add desired amount of solution into the solu-
tion tank and then close the cap.
WARNING
SAFETY WARNINGS:
Read all the instructions before installation and
operation of this appliance.
To reduce the risk of electrostatic shock,
continuously touch the copper strip on the
handle when the electrostatic switch is
turned on. Use caution when exchanging
hands; ensure one hand is touching the
copper strip at all times.
• To reduce the risk of injury, close supervision
is necessary when used near children.
• DO NOT contact moving parts.
• Only use attachments recommended or sold
by Global Industrial.
• To reduce the risk of electrical shock, do not
immerse electrode in water or other liquid.
• DO NOT touch or insert anything in the nozzle
of the sprayer while device is powered on. After
shutting down, the nozzle should be in contact
with the crop or the ground to eliminate residual
static electricity.
• Use only the battery and charger supplied by
Global Industrial.
• DO NOT let the nozzle touch objects while
spraying.
• DO NOT use static electricity in an environ-
ment with high humidity such as fog or rain.
• NEVER use static electricity during a lightning
storm.
IMPORTANT:
The electrostatic switch is located on the left
side of the base. This switch must be activated
before the power switch on the handle is turned
on. When the electrostatic switch is turned on,
user must touch the copper strip on the handle
at the same time.
Note:
The electrostatic sprayer is safe, and will
not cause any harm to the human body.
Note:
If the electrostatic needs to be tested, it
is safe to use a common electric pen to check if
the water in the tank is charged.
