The T-1400 has some simple instructions that must be carefully followed in order to create the
desired evaporative snowfall, ensure the safety of the operators/participants and to protect the
equipment from damage.
PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY.
Chart 2
Approximate Rotary Switch or Dial Remote Settings
Relative to Mounting Height to Minimize Residue
Rotary Switch
Setting
or Remote
Setting
900s
Snowflake Size
Mounting
Height
880-899
5
1/4 - 1/2 inch
30 ft
879-860
4
3/16 - 3/8 inch
25 ft
859-840
3
1/8 - 1/4 inch
20 ft
839-820
2
1/16 - 3/16 inch
15 ft
819-800
1
0 - 3/16 inch
10 ft*
* 10 ft is probably too low to prevent some residue on the ground.
3)
If the snow solution is a concentrate, prepare the snow solution in the empty plastic gallon bottle
provided (located in the T-1400 solution bottle well) per the “Solution Mixture” section of this manual
(See Chart 1). If the correct water/concentrate mix is not blended properly, the T-1400 may not create
the ideal evaporative snowflakes. Place the clear tube in the container with the “Solution Mixture”
and push it down so that the open end reaches the bottom of the filled container. The pump in the
T-1400 is self-priming.
4)
In order to start the T-1400, plug the Snow Machine power cord into an outlet with a 3
rd
lead
grounded conductor (preferably a Ground Fault Circuit Interrupt -GFCI). Next, turn the power
General Operating Instructions
Operating Instructions:
O
p
e
ra
ti
n
g
I
n
st
ru
ct
io
n
s
1)
Prepare the area you intend to direct your snowfall. Review “Diagram 1” on page 12 which shows
approximate spread of the evaporative snow. Always prepare your snowfall area making sure it is dry
and free of obstructions. Note that if the snowfall surface area is linoleum or smooth, and if the T-1400
is
mounted too low (See Chart 2), some flakes can create a slippery floor. Always locate the T-1400 in a
well-ventilated area.
Never block or cover the intake or nozzle discharge of the T-1400 or the
internal blower can be damaged.
2)
Mount the T-1400 on a secure, dry and level platform. Since the larger the flake size the slower
it will be to evaporate, Chart 2 recommends Rotary Switch or Remote settings to minimize residue on
the ground. For safety reasons, the T-1400 should be unplugged from the electrical outlet while placing
it in your desired location. The Nozzle should be pointed in the direction you want it to spray snow.
Hang or route the 30 ft. tethered remote as required to the desired operating location without
pinching
the wire. Do not operate the T-1400 in the rain. The T
-14
00 is not
waterproof. If it gets wet, unplug the
snow machine and contact Global Special Effects technical
support (256) 2
2
9-5551.
(Rain Covers are available, but not included)
