21
8.3.
Operation with Third Party Control Software
If this ExpressCube
™
countertop unit is used with third party software (i.e. not an ExpressCube
™
control panel), it is important that the user studies the documentation that is supplied with the third
party software.
It is not possible for the third party software to affect the integrity of the measurements output from
the ExpressCube
™
countertop. The acquired data is output only if the correct procedures have
been followed (zero condition, etc) and the output data itself is packaged with all related
measurement parameters in the data packet. However, it can be difficult for the user to initiate this
sequence without a full understanding of the software being used.
"
It is recommended that third party software users read the following operation
procedures for the ExpressCube
™
control panel. The procedure for obtaining a
measurement is identical and helpful points presented in the manipulation of the package
will be useful.
8.4.
Preparation for Measurements
The ExpressCube
™
countertop unit should be powered up and the ExpressCube
™
control panel
display finished the initial system check. Prior to starting measurements, it is recommended that the
platform and sensors be wiped with a damp rag to remove any accumulated dirt and/or debris.
Select the units and dimensional factor (if used) for measuring the parcel.
8.5.
Zeroing the ExpressCube Countertop
The ExpressCube Countertop will not record any measurements unless the platform has recorded
the Zero condition (weight of the platform in an idle condition) prior to a package being placed on the
platform. After verifying that the measurement platform is empty, press the ‘ZERO’ function button
on the ExpressCube
™
control panel.
The Blue LED under the platform will light and a zero condition will be indicated by the word ‘ZERO’
on the display of the ExpressCube
™
control panel. The Zero condition display for both of the
ExpressCube
™
control panels is illustrated below:
ExpressCube
™
Controller Display
