User’s Manual
4
Washdown Rated Stainless Steel
Pedestal and Wall Mounted Fan
PRE-INSTALLATION
:
All necessary screws are installed in the associate part for
ease of tracking for customer. Please use the following
pictures as guide to locate installation parts.
INSTALLATION INSTRUCTIONS
For the Washdown Rated Stainless Steel
Pedestal Fan
1.Loosen the screw from the base assembly, insert the lower
column to the base assembly. Align the hole of the lower
column and base assembly, then tighten it.
2.Loosen the screws from the upper pose, insert the upper
column to the lower column. Align the hole of the upper column
and lower column , then tighten it.
3.Align the motor flange and column.
4.Insert the pivot screw through the motor flange, column and
washer. Attach using the position nut and tighten it.
Insert the smaller position screw through the bottom radius.
Attach it with the position nut.
5.Unscrew the nuts and washers from the motor
.
6.Arrange the rear guard in its proper position.
7.Attach the rear guard by inserting and tightening the nuts to the
motor (through the eyelets on the guard).
8.Insert the blade into the motor shaft until it reaches a stopping
point and the set screw is in line with the flat groove on the
motor shaft.
NOTE:
Make sure the blade’s set screw is facing the motor. You
may need to loosen the set screw at the rear of the blade to slide
it onto the shaft.
9.Firmly tighten the blade’s set screw with the spanner (not
supplied).
CAUTION:
Do not alter the angle of the blades.
10.Hang front grill on top rib of rear grill by utilizing the “U”
shaped fixed clip at top of front grill rim.
