3
KIT CONTENTS
If you find any parts missing or damaged, please contact us as soon as possible,
using the Customer Service Information on page # 2.
❑
(A) Fuselage w/Carbon Support Strips - 1
❑
(B) Top Wing and Ailerons w/Carbon Support Strips - 1
❑
(C) Bottom Wing and Ailerons w/Carbon Support Strips - 1
❑
(D) Stabilizer w/Elevator - 1
❑
(E) Rudder - 1
❑
(F) Balsa Triangle Stock - 1
❑
(G) Carbon Landing Gear Struts - 2
DEPENDING ON THE KIT YOU HAVE, IT MAY LOOK DIFFERENT FROM THE KIT SHOWN. THE ULTIMATE KIT IS SHOWN.
❑
(H) Landing Gear Parts Bag - 1
❑
(I) Control Horn and Clevis Bag - 1
❑
(J) Motor Mount and Hinge Tape Bag - 1
❑
(K) Aileron Interlink Connector Bag - 1
❑
(L) Pushrod Wires - 4
❑
(M) Wheel Pant Assemblies - 2
❑
(N) Wing Struts - 2
I
K
F
H
E
G
B
J
D
A
C
L
M
N
TOOLS AND SUPPLIES REQUIRED
Pacer Zap-O C/A+
for Foam
Pacer Aerosol Zip-Kicker
Builder's Triangle
or Square
Small Phillips Head
Screwdriver
Modeling Knife
w/#11 Blade
Wire Cutters
Z-Bend Pliers
Self-Adhesive
Velcro
Drill w/Assorted
Drill Bits
220 Sandpaper
w/Sanding Block
Straight Edge
Ruler
Pencil
Double-Sided
Tape
To save weight and make building time quicker, we suggest using foam-friendly C/A instead of epoxy to assemble the airplane.
If you use C/A, you
MUST USE FOAM-FRIENDLY C/A AND FOAM-FRIENDLY C/A "KICKER."
If you use C/A and C/A "Kicker"
that is not foam-friendly, the C/A will melt the foam and ruin the airplane.
If you're installing the recommended KMS 2410-9 brushless motor, you will need to make a motor mounting plate out of a piece
of 1/8" plywood. A template and mounting instructions are included on page # 15.
