13
❑
Check that the servo arm is still centered, then center both ailerons.
❑
Install the Z-Bends into the outermost holes in the servo arm, then
cut the pushrod wires to length, snap the clevises into the outermost
holes in the control horns, and glue the clevises to the pushrod wires.
STEP # 11: INSTALLING THE AILERON INTERLINK PUSHRODS
❑
Glue one plastic pushrod mount to the bottom of each aileron.
Position the pushrod mounts in the center of the ailerons.
❑
Make a Z-Bend in one end of one pushrod wire.
❑
Secure the Z-Bend into the outermost hole in the upper pushrod
mount.
❑
Center the top and bottom ailerons, cut the pushrod wire to length,
snap a clevis into the outermost hole in the lower pushrod mount, and
glue the clevis to the pushrod wire.
❑
Repeat the previous procedures to install the second aileron interlink pushrod.
STEP # 12: INSTALLING YOUR RECEIVER AND ESC
❑
Install your receiver and ESC onto the left side of the fuselage, using
velcro or double-sided tape.
❑
Extend the antenna along the bottom of the fuselage and hold it in
place using small pieces of clear tape.
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
You will need to make a small hole through the fuselage so that the rudder servo lead can be plugged into the
receiver. You will also need to make a small hole in front of the ESC for the battery plug. The battery will be mounted on the right
side of the fuselage.
Continued On Next Page
☛
☛
☛
☛
☛
