11
Continued On Next Page
☛
☛
☛
☛
☛
❑
Center the elevator servo, then attach the servo arm onto the servo,
making sure that it's centered and pointing down.
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
Remember to install the servo arm retaining screw,
to secure the servo arm to the servo.
❑
Slide one pushrod support (extra control horn) over the end of the
pushrod wire.
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
Don't glue the pushrod support to the side of the
fuselage yet. Glue it into place
AFTER
installing the clevis.
❑
Check that the servo arm is still centered, then center the elevator.
❑
Cut the pushrod wire to length and slide one clevis over the end of
the pushrod wire.
❑
Snap the clevis into the outermost hole in the control horn, then glue
the clevis to the pushrod wire.
❑
Center the pushrod support, then glue it to the fuselage side.
❑
Install one control horn onto the right side of the rudder, 1-7/8"
(47.5mm) above the bottom of the rudder.
❑
Make a Z-Bend and V-Shaped bend in one end of one pushrod wire.
❑
Install the Z-Bend into the servo arm, then attach the servo arm onto
the servo, making sure that it's centered and pointing down.
STEP # 9: INSTALLING THE RUDDER PUSHROD
