Global garden products TH4X 102, Workshop Manual, Page: 40 / 85

Find and undo all the screws holding the engine to the
frame, grip the engine firmly and lift it, taking the nec-
essary care.
NOTE
Some engines are held with screws of different length
and in different positions, so it is best to label them so
that no errors are made on reassembly.
On reassembly, fully tighten the screws for the engine
and the pulley to the amo
unts shown.
➤
For models with electromagnetic clutch:
ensure that the pin (11) is inserted into the clutch
spline (7) and remember to refit the spring (6) .
Remember to fit the clamps back on the fuel pipe and
check that it does not leak .
Reattach all the electrical and earth contacts and refit
the protection covers.
➤
For hydrostatic drive models: reset the
stretcher spring tension should it have been slack-
ened [see 4.4].
Reattach the accelerator cable and ...
Adjust the «MINIMUM» position [see 6.10].
Refit the front hood [see 5.1].
➤
For models with electromagnetic clutch:
reset the adjuster (1) and check the spring tension
[see 4.1].
Tightening torques
1-1a Screw for pulley ........................... 45 ÷ 50 Nm
– Screws for engine fastening ............... 25 ÷ 30 Nm
3/2002
11
7
102 - 122
5.5 .
0
- REMOVAL OF THE ENGINE
2 / 2
from
2000
to
••••
WORKSHOP MANUAL
page
<= ... RET ... <=