5.5 REMOVAL OF THE ENGINE
Since there are different types of drive, the stages
described here refer to those shared or similar in
all types of engine.
Remove the front hood [see 5.1].
Disengage the blades to loosen the belt. In order to
have better access to the parts concerned, also the
drive belt should be loosened.
This is done by ...
➤
In mechanical drive models:
engaging the
parking brake
➤
In hydrostatic drive models:
loosening the
nut
(1)
of the stretcher.
Loosen the screw
(2)
, unfasten the safety pin
(3)
and move the fork to the side
(4)
.
Turn the belt shifter
(5)
forward until the belt
(6)
is
released from the pulley
(7)
.
Undo the central screw
(8)
and take out the pulley
(7)
from the shaft.
If it is difficult to take out, use the special extractor #
code 60253000/0 inserted into the holes
(9)
of the
pulley, but do not completely undo the screw
(8)
so
that the extractor puts pressure on the head of the
screw and does not damage the threaded hole of
the shaft.
Remove the protection from the exhaust
(10)
and
disconnect the cable control from the accelerator
and all the electrical wires.
Detach the fuel line pipe,
taking care not to spill
fuel
.
10
4/2005
8
7
9
5
7
6
5
3
4
2
1
92
5.5
.
1
REMOVAL OF THE ENGINE
1 / 2
WORKSHOP MANUAL
page
from
2003
to
••••
© by GLOBAL GARDEN PRODUCTS
