42
⚠
Safety Warning
It is safer to be seated in the OEM vehicle seat using the OEM restraint system than
seated in a wheelchair using the approved restraint systems.
For this reason, where feasible, wheelchair users should transfer to the vehicle
manufactured installed seat using the (OEM) restraint system.
Unoccupied wheelchair should be stored in the cargo area and secured during travel.
1.
Wheelchair users should transfer to the vehicle seat and use the vehicle-
manufacturer-installed restraint systems whenever it is feasible, and the
unoccupied wheelchair should be stored in a cargo area or secured in the
vehicle during travel.
2.
The CentroGlide complies with ISO 7176-19 & AS/NZS 3696.19 and has been
tested for use in a forward facing position ONLY.
3.
The user must not weigh more than 159kg for CentroGlide secured with a 4
point WTORS and 136kg secured with a Dahl Docking station.
4.
When wheelchair is used as Occupant Transport the wheelchair must be in
the forward facing position.
5.
Use a 4 point strap type wheelchair tie-down. This could be a hook attached
to the Tiedown strap end or if no fitting is supplied loop the Tiedown webbing
through the securement point to the tiedown. (refer standards below)
6.
Use a Three-point-belt restraint comprising a pelvic-belt restraint and a
shoulder-belt restraint that connect together near the hip of the occupant.
7.
Only use the designated Tie-down points located on wheelchair. Two front,
two rear. (Fig. 11)
8.
Use only WTORS (Wheelchair Tie-down and Occupant Restraint System) that
complies and installed to the requirements of ISO 10542-1 or ADR 4/04 or
AS/NZS 2596 or equivalent.
Summary of Contents for CentroGlide
Page 37: ...37 ...
Page 39: ...39 ...
Page 50: ...50 Dahl CentroGlide adaption kit 502237 ...
Page 64: ...64 ...
