SECTION 5. TRANSPORTING YOUR POWER CHAIR
Transporting your Power Chair in motor vehicles can be easily achieved by the
following methods
.
STATION WAGON
The backrest folds down onto the seat by pulling out pins
A
,
B
, and
C
(see
Fig 2
below)
Note:
Pins
A
&
B
are released by first pulling them out and then twisting. They will
then remain out allowing a free hand to release Pin
C
(by same method as for pins A &
B) allowing you to lower backrest forward onto the seat. The linkage system will allow
the back to lie flat on the seat.
TRANSPORTING IN A SPECIAL WHEELCHAIR TAXI, BUS OR
PRIVATE VEHICLE WHILE THE USER IS IN CHAIR.
To date there is no recognized Australian Standard that covers wheelchairs suitable for
vehicle transport while the user is in the chair. The Series 6/7 wheelchair has undergone
Static Pull test for the Vehicle Tie Down Location points to a load specified by the
NATA test laboratory and in accordance with Standards requirements. It is
recommended that a 4-point tie down system is used for anchoring the chair to the
vehicle in conjunction with the occupant restraint system, that must comply with
AS2942-1994. Where possible, wheelchair occupants should be transferred into and use
the proper vehicle seat and restraints
CAUTION : Do not use legrests or footplates as attachment points for your tie
down system.
Do not use armrests as attachment points for your tie down system.
Unoccupied wheelchairs in vehicles must be safely secured or stored securely
outside the passenger compartment.
Posture Positioning Belts should not be used as vehicle restraint belts.
NOTE
:
Ensure that your restraint system complies with AS2942 and you fully
understand the manufacturer instructions on how your tie down system works and
whether it is compatible with the Glide Power Chair.
