■
T he l ight s ha dow i s f ogging:
◎
Please check the data on the DMX 512 controller is suitable for the electric focus.
◎
Please check the machenical parts is jamging.After cleaning,please add some temperature -durable juice.
■
T he l ight w ork s i nterruptly :
◎
Please check if the fan works normally or mote clogging.
◎
Please check whether the abstract heat have the mote clogging.
◎
Please check if the lamp is to the usage life.
◎
Please check if the power supply is enough,the connection of the power supply or the circuit are good.
◎
Please check if the switch of the sup-temperature is good.
■
T hough t he l ight i s l ighting, but i t c ouldn't a c c ept t he c ontrol o rder:
◎
Please check the start code address and the function option are correct.
◎
Please check whether the communicate control cable is ongood connection or the cable is too long or interrupt.
◎
Please check the control system is not valid,check the singal amplifier of chain connected is valid.
◎
Please check whether the communicate cable is too long or the other equipment is mutually conjugate.
◎
Please arrange the wire well ,,Shorter the signal cable ,put the high voltage cable and low voltage cable separ
-ately .
◎
Add the signal amplify isolator.
◎
Signal cable is used the excellent screening doublet (Resistance 75
Ω）
◎
The end of the light end and the end resistance.
◎
When the lamp don't cool down enough but do the incorrect operation will let the trigger up to super- high
voltage leak.It will damage the electric circuit and communicate IC or CPU .Under this condition,please
change the PCB board.
■
the l ight c a n't m ov e:
◎
Please check if the power supply is suitable for the light voltage data.
◎
Please check the fuse of input voltage is defective.
◎
Please check the light if they are deformating,inside parts is broken,become wet...etc will lead the loose contact.
◎
Please check if the inside lead wire and the connector is loose.
◎
Please check the electric parts (such as the switch,transformer,ballast,electric capacity,piezoresistor, filter,
PCB board,controller to motor) is short-circuit or burn down.
■
◎
◎
◎
◎
◎
■
◎
◎
◎
◎
Re-projector reset.
P a rt o f t he p rojec tor c ouldn't b e r es pons led t o t he c ontrolling o rder:
Please check the order is correct to the moving.
Please check the mechanicalpart is deformation or loose.
Please check the function to the motor socket is loose or drive chip is burn down.
Please check the wire of the motor is cut at zig point.
Please check these function to the motor is damaged.
O n w ork ing, the p a n & tilt c ouldn't w ork n orma lly :
Please check according to the above step by step.
Please check the belt of the X.Y is broken.
Please check the X/Y direction data to the receiver is damage.
DUTY EX
ONERA TIVE AND COPYRIGHT PR
OTECTION
◇
The lamp belongs to consumption products that is not guaran
to keep it in good repair
◇
Any products broken that didn't according to the instruction is not guarantee to keep it in good repair.
◇
The commentary for all the instruction belongs to the supplier in final.
◇
No authorize can't copy.
◇
tee
.
The information in this manual may be changed in the future,the company reserve the right to change
the data without any advise.
