GLG Lighting products
5
Building a serial Master-slave / DMX-chain:
For Master-slave connection, you need to set a device as the Master device. All other devices will
be the slave devices.
Connect the DMX-output of the first device (Master) in the chain with the DMX-input of the
second device (the first slave device). Connect the DMX-output of the second device (the first
slave device) with the DMX-input of the third device (the second slave device). Always connect
one output with the input of the next device until all devices are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
Ω
resistor between Signal (-) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of
the last fixture.
4. Control panel and display
The control panel on the device allows you to control the device, including DMX start address
setting, Automatic operation setting, Manuel dimmer, Rainbow effect setup, etc.
Display window
The device use a 4-digits red color LED display module for displaying your setting.
The module can display some simple letters and figures.
