(a) The Red and Green lights should start alternating
(b) This means the module is ready for setup
Note: In order to get your messages during a power outage,
you will need to provide DC power to the WiFi module. If you
also have a Pro Series backup system, we recommend using
the 12 volt battery providing backup power to your backup
system (Go to 2C-8). If you do not have a backup system,
you must use the included 6V battery pack (Go to 2C-9)
8.
If you also have a Pro Series backup sump pump
(a) Using the 6 foot 12
volt battery cable,
attach the large
ringlug labeled
‘positive’ (+), to the
positive post of
the battery
(b)
Attach the smaller ringlug labeled negative (-) to the
negative post of the battery
(c) Plug the power jack at the
other end of the wire into the
12V/6V DC Battery port on the
bottom of the Module
9.
If you do not have a Pro Series
backup sump pump
(a)
Install four AA-batteries
into the 6V Battery pack
(b) Make sure the switch on
the battery pack is in the
‘ON’ position
(c) Plug the battery pack into
the 12V/6V DC port on the bottom of the module
2D. Attaching your WiFi Module to your Deluxe
Float controller with a Remote Terminal
This section will explain how to connect your WiFi Module
to your Deluxe Controller (DFC2, VSC2, TSC2 or DVSA) using
the remote terminal and the included remote terminal
cable. Using the remote terminal cable will provide a
general notification stating that your system is alarming.
This connection style is compatible with all models that
include a remote terminal.
Note: This connection style should not be used if your C2
controller is a Pro Series Connect and has a USB port. You
will only connect via the USB port.
1. Using the 3 foot remote terminal cable,
attach one end of the cable labeled ‘NO’
to the Normally Open port labeled ‘NO’
on the side of the deluxe control box.
Turn the screw clockwise to secure the wire.
2. On the same end of the remote terminal
cable, attach the cable end labeled ‘COM’ to the Common
port labeled ‘COM’ on the side of the deluxe control box.
Turn the screw clockwise to secure the wire.
3. Attach the other end of the
cable labeled ‘NO’ to the
Normally Open port labeled
‘NO’ on the right side of the
WiFi module. Turn the screw
clockwise to secure the wire.
4. On the same end of the remote terminal cable, attach
the cable end labeled ‘COM’ to the Common port labeled
‘COM’ on the right side of the WiFi module. Turn the
screw clockwise to secure the wire.
5. Connect the USB charger to the 5V DC power port of the
WiFi module using the included mini USB cable
6. Plug the other end of the USB charger into your power
outlet
7. The red and green lights on the WiFi module should
start alternating. This means that it is ready for setup.
Note: In order to get your messages during a power outage,
you will need to provide DC power to the WiFi module. If you
also have a Pro Series backup system, we recommend using
the 12 volt battery providing backup power to your backup
system (Go to 2D-8). If you do not have a backup system,
you must use the included 6V battery pack (Go to 2D-11)
8.
Using the 6 foot, 12
volt battery cable,
attach the large
ringlug labeled
‘positive’ (+), to the
positive post of the
battery.
4
-
+
-
+
battery
pack