FCC Guidelines
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
- Contains FCC ID: W7OMRF24WG0MAMB
- To satisfy FCC RF Exposure requirements for mobile and
base station transmission devices, a separation distance
of 20 cm or more should be maintained between the
antenna of this device and persons during operation.
To ensure compliance, operation at closer than this
distance is not recommended. The antenna(s) used for
this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
10
Warning
Changes or modifications not expressly approved by
Glentronics could void the user’s authority to operate
the equipment.
Troubleshooting guide
Problem
Red light is on steady
The red/green lights keep
alternating after the setup
process
Green light is flashing
Green light is steady, red
light is flashing
Red and green lights are
on steady
Solution
Check your router and
internet connection. Then,
power cycle the module.
Unplug the module from the
wall and disconnect from
the battery. Let it sit for a
minute then reconnect both
power sources.
Press the reset button with
a paper clip and restart the
setup process
Replace 4xAA batteries in
the battery pack (DFC2,
VSC2, TSC2 or DVSA)
Communication error. Power
cycle the module. Unplug the
module from the wall and
disconnect from the battery.
Let it sit for a minute then
reconnect both power
sources. If red light is still
flashing in 24 hours, call
Glentronics support
Reset the WiFi module by
pressing the ‘reset’ button
with a paperclip for 5
seconds and restart the
setup process.