Page
16
of
25
Mix Busses
There are two main stereo mix busses within the Bella 22. These are referred to as
‘MIX/ SOLO’ or just ‘MIX’.
In simple terms the ‘MIX/ SOLO’ outputs are derived after the front panel Channel
On/ Solo buttons. If a channels on switch is off its output will not be sent to the MIX/
SOLO buss. If the soloing feature is used (i.e. a front panel solo button held down)
then the MIX/ SOLO buss will output just the solo’d channels audio.
The ‘MIX’ outputs are a permanently on mix. The front panel Channel On/ Solo
buttons do NOT affect this mix, all 10 inputs are always fed into this mix buss.
The MIX outputs are only available as network audio outputs and are available either
pre or post the master volume control (no volume or with volume) control. The LS
dim or cut circuits never affect these outputs.
The MIX/ SOLO outputs are routed to the analogue and AES3 outputs which are
always post the master volume control and also always affected by the dim and cut
circuits. There are also 2 sets of this mix routed to the network outputs, 1 set is post
master volume, dim & cut and the 2
nd
set is pre master volume, dim & cut.
