Page
22
of
33
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The Beatrice M1 will have been named at the factory during test to allow them to be
identified by the Dante controller.
The format used for the factory name is:
‘GLENSOUND-BEA-M1-SN-XXXX’
Where ‘BEA-M1’ refers to the Glensound product i.e. Beatrice M1.
The ‘SN-XXXX’ refers to the serial number of the Beatrice M1 which can be found
printed on the rear or side of the unit.
The unit may be renamed in
Dante controller by opening the ‘Device view’ window
and selecting Beatrice M1 in the drop-down menu. Go to
the ‘Device Config’ tab and
change the name with the Rename Device box.
Note if you upload a new DNT file or clear the devices config then the name will
change to ‘BEA-M1-xxXxXx’ whereby the ‘X’s refer to the devices MAC address.
Dante Controller TIP
If you have never run Dante controller before then make sure that on the bottom left
of the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates
