Glenmac Harley Pro 6, Operator'S Manual

Page: 27 / 39

25 PN-P970620 (03/2005)
CAUTION
•
Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and
head.
WARNING
•
Keep hands and body away from pressurized
lines. Use paper or cardboard, not body parts
to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily
penetrate skin and will cause serious injury or
death.
•
Make sure that all operating and service
personnel know that in the event hydraulic fluid
penetrates skin, it must be surgically removed
as soon as possible by a doctor familiar with
this form of injury, or gangrene, serious injury,
or death will result. CONTACT A
PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
•
Route hydraulic hoses carefully to prevent
damage. Hoses must not be twisted, bent
sharply, kinked, frayed, pinched, or come into
contact with any moving parts. Operate
moveable components through full operational
range to check clearances. Replace any
damaged hoses immediately.
•
Do not allow other people in the area when
operating, attaching, removing, assembling, or
servicing equipment.
•
Do not modify or alter, or permit anyone else
to modify or alter, the equipment or any of its
components in any way.
SET-UP INSTRUCTIONS
The power rake is shipped partially assembled.
Assembly will be easier if components are aligned and
loosely assembled before tightening hardware.
Recommended torque values for hardware are located
on pages 5 & 6.
Select a suitable working area. Refer to illustrations,
accompanying text, parts lists, and exploded view
drawings.
Tools Required
3/4" and 9/16" Wrench
Rubber hammer
It is advisable to have a mechanical lifting device to
facilitate uncrating.
Do not attempt to lift frame
components alone.
Unpacking Crate
Be careful of nails in boards when uncrating.
Remove top, sides, and ends of crate.
Remove scarifier.
Remove gauge wheel assemblies.
Remove parts box.
Remove power rake from crate. Remove loose nails
from boards and dispose of crate according to local
codes.
ASSEMBLY PROCEDURE
WARNING
•
Do not allow other people in the area when
operating, attaching, removing, assembling, or
servicing equipment.
1. Lift front of rake up, insert leg stand (#126) into the
rectangular tubing on the left side of the mast, insert
pin (#127) and attach hair pin clip.
Do NOT add front PTO half to power rake yet. Follow
instructions and important notice concerning the front
PTO in the “Attaching and Detaching Power Rake”
section page 12.
2. Insert the left (#122) and right (#123) scarifier lift
mounts into the rectangular tubing on the mast
assembly with the “U” brackets toward the front and
attach rod end of hydraulic cylinder to the lift mounts
using hair pin clips to hold in place.
3. Center and attach the scarifier unit to the lift mounts
with two 3/8" x 2-3/4" bolts, nuts, lock washers, and
tighten securely.
4. Attach the third hitch point (#148) and the hydraulic
selector valve assembly to the top of the mast with
two 1/2" U-bolts, nuts, and lock washers. Upper hitch
pin is a 3/4" x 3-3/4" pin with large flat washer and hair
pin clip.
ASSEMBLY