001-193
PAGE 2 of 7
Accu-Finish
SERIES II
A
TABLE LEVER HANDLE
BALL BEARING (4)
METAL RETAINER STRIP
S E R I E S I I
TABLE LOCK
This knob locks the table in position. Loosen
it when you want to oscillate the table.
Tighten it to hold the table in place.
B
C
8. Replace the retainer bar with
the two Phillips head screws.
Make sure the rubber bumper
is oriented properly. It should be
directly across from the rubber
bumper on the other side and the
rubber pointy nub on the outside.
9. See C for how to lock table.
*A definite resistance will be
encountered with engaging the
second set of bearings. This is due
to the preloaded design in which the
bearings actually squeeze the mating
track. Align bearings with machined
track before using any force. When
properly aligned, only a slight nudge
is required to urge the table over the
second set.
4. Note there are four (4) ball
bearings mounted on the table
support structure. These bearings
allow the table to roll.
5. Place the table face down on
your work bench. Find the metal
retainer strip located at each
end. From only one strip, remove
the two screws with a Phillips
screwdriver (B). Note the small
rubber bumper.
6. Turn the table face up and start
the table onto the first set of
bearings, making sure they locate
properly in the machined tracks.
7. Slide table across until the
second set of bearing* contacts
to the end of the track (B).
Confirm proper alignment, then
slide table the rest of the way.
Installation
1. Unpack the machine and parts on
a suitable work surface.
2. Rotate the motor housing up and
back until the wheel spindle is
oriented in the vertical position (A).
3. For easier table installation, loosen
table support by pulling the handle
left. Rotate the support up until it is
at approximately 0°. Lock handle.
Attaching A Wheel
Select the wheel you wish to use
(see application chart below). Attach
wheel to machine with the flat head
machine screw using the 3/16" hex
T-wrench. To ensure proper wheel
trueness, make sure that the back of
the wheel and the spindle face are
clean when mounting wheels.
Wheel Use For
260 Grit Roughing & Shaping
360 Grit Carbide Roughing
600 Grit General Purpose
1200 Grit Fine Finish
Ceramic Lap Mirror Finish
See back page for wheels available
to use with Accu-Finish.
READ ALL DIRECTIONS before attempting setup or installation of this machine.
