PAGE 5 of 7
001-193
Drive Belt Replacement
Disconnect machine from electrical
power. Remove rear panel from
machine by removing four (4) Phillips
screws. Roll the old belt(s) off, first
from the small pulley and then from
the large pulley. Place new belt(s)
over the large pulley first, align
with small pulley and roll them on.
Replace rear panel.
Lift Kit
Included with your Accu-Finish
Series II is a lift kit. This is for those
who wish to raise the wheel center
higher above the table. Because
some fixtures on the market are taller
than Accu-Finish fixtures, the lift kit
will allow the use of those fixtures.
TO INSTALL LIFT KIT
Remove the side bolts (one located
each side) that hold the motor
housing. Separate the motor housing
from the base. On each side, switch
the bolt bushings and the plastic
plugs. (
I
).
From the center base, remove the
bolts that hold the latch magnet. Turn
the magnet brackets 90º. Move the
magnet to the top and replace the
bolts (
I
). Remove the two rubber
stops located at the back. Push the
bolt out of the center of each and
replace with the long bolt that comes
with the lift kit. Insert the long bolt
through the plastic extensions and
replace on base. Reattach the motor
housing unit to the side arms.
S E R I E
S I I
Heavy-Duty Lamp Kit
Order #001-756 - 115 Volt
Order #001-951 - 230 Volt
Extra heavy-duty, UL listed lamp
has 24" flexible neck that is sealed
against oil and grit. This lamp stays
where you put it. Quick-mount
bracket for easy installation.
Rated to a bright 100 watts to
give plenty of work light. Insulated
shade stays cool.
Power Foot Switch
Order #002-205
Turn the machine ON
and OFF with both
hands free. Especially
useful for horizontal
lapping. Comes prewired for
standard 3-wire, 115 Volt grounded
outlet. UL listed to 1/2 HP.
S E R I E S I I
Inspection
The better you can see, the better
the results!
This Accu-Finish microscope system
is unique because you can inspect
and work under it. This difference is
critical. The large focal length gives
you plenty of distance under the
microscope for hand tools, power
tools, measuring and gauging tools.
Work is done with absolute
clarity and precision without
eye fatigue.
ACCESSORIES
For more information about
Accu-Finish products visit
www.accu-finish.com
or call 1-800-835-3519
I
Table removed to
show detail
LIFT KIT
EXTENSION POSTS
& LONG BOLTS
MAGNET
BRACKET