28
EEC4 Installation Manual
Throttle Delay Options
The Throttle Delay Option allows you to configure the EEC system to delay throttle output as you shift
from Neutral, past in-gear idle, and into the throttle range.
Press ACTIVE
4 times for
Throttle Delay
Option
WARM LED will begin to flash
Press
WARM to
activate
selection
NO LEDs will be illuminated
Press
WARM to
save option
selection
You may continue to other configuration options
on the following pages or you may choose to
EXIT CONFIGURATION MODE by turning
system OFF, moving control handles back to
NEUTRAL, and then turn system ON again.
Press &
Release
ACTIVE
to cycle
through
Throttle Delay
Options
1
2
3
4
5
ACTION
LEDs ON
AMOUNT OF DELAY
None
None
Port Neutral
0.5 second
Active
1.0 second (Default)
Port Neutral & Active
1.5 second
Warm
2.0 second
6
Port Neutral & Warm
2.5 second
RESULT
Enter Configuration Mode as described in section 2.4A (pg. 29)
Configurable
0-2.5 second
Delay
Moving handles from Neutral,
past in-gear idle into throttle range . . .
To Change Throttle Delay Setting Follow These Steps:
system will shift transmission
into gear and pause . . .
(Default = 1 second)
before RPMs are increased.
above idle
Neutral
Throttle
range
