F
F
tear, such as gaskets, light bulbs, etc. The specific instructions for each procedure of this kind are provided
below.
Before carrying out any operation involving access to live parts, disconnect the appliance from the electricity
supply.
9.1 Replacing the Oven Lamp
·
Disconnect the oven from the power supply by means of the omnipolar switch used to connect the
appliance to the electrical mains ;or unplug the appliance if the plug is accessible ;
·
Remove the glass cover of the lamp-holder ;
·
Remove the lamp and replace with a lamp resistant to high temperatures (300
℃
)with the following
characteristics:
Voltage: 220-240V
Wattage: 25W
Type: E 14
·
Replace the glass cover and reconnect the oven to the mains power supply .
9.2 Removing doors
For a more thorough clean, you can remove the oven door. Choose the remove and assemble method
According to different structure of oven door purchased. Proceed as follows:
Oven door structures 1 remove and assemble procedure:
·
Open the door fully ;
·
Lift up and turn the small levers situated on the two hinges ;
·
Grip the door on the two external sides ,shut it slowly but not
Completely;
Pull the door towards you ,pulling it out of its seat ;
Reassemble the door by following the above procedures backwards.
Oven door structures 2 remove and assemble procedure:
·
Open the door fully ;
·
lift up and turn the small levers located on the two hinges ;
·
Grip the door on the two external sides and close it approximately half
Way. Unlock the door by pressing on the clamps
F
,and then pull the door tow-
ards you lifting it out of its seat. To replace the door, reverse this sequence.
