Page 5
Stainless Lite
DIRECT SOLAR
Stainless Lite
INDIRECT SOLAR
Figure 3
Figure 4
Pipework is not supplied by manufacturer,
but to be supplied and fitted by installer.
Stainless Lite Direct Solar
Stainless Lite direct is an electrically heated,
unvented hot water storage cylinder designed
primarily for use with off peak electrical
supplies.
It is supplied fitted with two 3kW immersion
heaters which are BEAB approved for safety as
recommended by the Electricity Council.
A high efficiency coil is positioned in the lower
part of the Stainless Lite vessel to ensure
maximum benefit of solar gain energy.
Stainless Lite direct models are listed in
Table 1 on Page 6 & 7.
Stainless Lite Indirect Solar
Stainless Lite indirect is an unvented hot
water storage cylinder and is provided with a
high efficiency internal primary coil which is
designed for use with a gas or oil boiler and
is suitable for both open vented and sealed
pumped primary systems.
When used with a sealed heating system the
boiler must incorporate its own energy cut-out
overheat thermostat.
A high efficiency second solar coil is positioned
below the primary coil to ensure maximum
benefit of solar gain energy.
Stainless Lite indirect models are listed in
Table 2 on Page 8 & 9.
Note:
The cold supply elbow c/w drain tapping
must be fitted as shown in figs 1, 2, 3 and
4. A flexible hose can then be connected to
the drain tapping and, providing the hose
runs below the lowest level of the cylinder,
then all the water contents can be drained
out by syphonic action. (The cold feed pipe
dips internally to the base of the cylinder.)
DESIGN
DESCRIPTION
