gledhill Stainless Lite Direct 90-300 litres, Design, Installation & Servicing Instructions

Page: 2 / 32

Page 2
Section Page
DESIGN
Description 3
Technical Information 6
System Design 8
INSTALLATION
Installation 10
Commissioning 19
USER INSTRUCTIONS 20
SERVICING AND MAINTENANCE
Servicing and Maintenance 21
Fault Finding 22
Short Parts List 25
ADDENDIX
Addendix A 26
Addendix B 27
Service Record 28
Notes 29
Terms & Conditions 30
ISSUE 9: 05-09
These instructions should be read in conjunction with the installation/servicing
instructions issued by the manufacturer of the heat source being used.
Any installation must be in accordance with the relevant requirements of the Gas
Safety Regulations, Building Regulations, I.E.E. Wiring Regulations and the Water Fitting
Regulations (England and Wales) or Water Byelaws (Scotland). It should be read in
accordance with the relevant recommendations of the following:
BS 6798; BS 5549; BS 5546;
BS 5440:1; BS 5440:2; CP 331:3
BS 6700: BS 5258 and BS 7593: 1992
Stainless Lite is covered by Section G3 of the Building Regulations (England and
Wales) Technical Standard P3 (Scotland) and Building Regulation P5 (Northern Ireland.
Compliance can be achieved via a Competent Person Self Certifi cation Scheme or
notifi caton of installation to the Local Authority Building Control Department.
It must be installed by a competent person as defi ned by the relevant regulations.
Manufacturers notes must NOT be taken as over-riding statutory obligations.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety. Children should be supervised at all times to
ensure they do not play with the appliance.
This information is provided to assist generally in the selection of equipment.
Responsibility for selection and specifi cation of our equipment must however remain that
of our customer and any experts or consultants concerned with the installation(s).
PLEASE NOTE: THAT WE DO NOT THEREFORE ACCEPT ANY RESPONSIBILITY FOR
MATTERS OF DESIGN SELECTION OR SPECIFICATION, FOR THE EFFECTIVENESS
OF AN INSTALLATION OR SYSTEM CONTAINING ONE OF OUR PRODUCTS UNLESS
SPECIFICALLY REQUESTED TO DO SO IN WRITING.
All goods are sold subject to our Conditions of Sale which are set out at the rear of this
specifi cation. In the interest of continuously improving the Stainless Lite range, Gledhill
Building Products Limited reserve the right to modify the product without notice, and
in these circumstances this booklet, which is accurate at the time of printing, should
be disregarded. An updated set of Instructions will be produced and supplied with
new appliances and will be made available for other appliances on request.
A KIWA PRODUCT APPROVED TO COMPLY WITH ALL RELEVANT PARTS OF THE BUILDING
REGULATIONS AND WATER SUPPLY (WATER FITTINGS) REGULATIONS.
Stainless Lite IS PRODUCED UNDER AN ISO 9001:2008 QUALITY MANAGEMENT SYSTEM
APPROVED BY BSI.
As part of the industry wide “benchmark” initiative all Gledhill Stainless Lite appliances now
include a Benchmark Installation, Commissioning and Service Record Log Book. Please read
carefully and complete all sections relevant to the appliance installation. Carrying out the
work required and completing the Log Book will satisfy the requirements of the Building
Regulations for commissioning as set out in the Domestic Heating Compliance Guide. The
details of the Log Book will be required in the event of any warranty work being required.
There is also a section to be completed after each regular service visit. The completed
Log Book and these instructions should be left with the cylinder.