D E S C R I P T I O N
ELECTRIC IMMERSION HEATERS
The immersion heaters used are 14” 3kW low watts
density units with incaloy 825 immersion sheaths, and
matching 11” rod thermostats which should be set to
77
0
C. They are BEAB approved and have been chosen
to meet the requirements of the Maxistore specification
produced specially for Ecomony 7 products by the
Electricity Industry.
It is recommended that replacements should be obtained
only from Gledhill Water Storage.
5
Table 1.1 Technical Specification of PulsaCoil III
MODEL
PC144
PC190
PC210
PC245
Overall dimensions of store
1650 x 525 1840 x 550 1840 x 575 1960 x 575
(Height x Diameter)
Minimum cupboard size
(Width x Depth)
700 x 550 715 x 600 750 x 650 750 x 650
Nominal store capacity (litres)
160
205
230
250
Weight (kg)
Empty
39
41
46
52
Full
199
246
276
302
Hot water flow rate (litres/min)
35
35
35
35
Typical dwelling types
Bedrooms
1 - 2
2 - 3
2 - 3
2 - 4
Bathrooms
1 or
1
1
2
En-suite shower rooms
1
1
2
1
NOTES
1.
The PC245 model can be installed in a property with greater hot water demand. However this will require
more ‘ON peak’ electricity to recharge the store.
2.
The standard pattern is manual fill. If automatic fill patterns are required please speak to our Technical
Sales Office.
3.
The flow rates are for 35
0
C average temperature rise and assume normal pressure and adequate flow to
the appliance.
4.
For hard water areas use suffix ‘H’, for soft water areas use suffix ‘S’ after the model number, e.g.
PC144H = PulsaCoil mk III model 144 for hard water areas.
5.
A minimum of 200mm should be available above the appliance to allow it to be filled and the water level
checked.
.
.
.
.
.
