|
14
EN EN
3.5 Installing the Lengths of Material
• (Fig. 7) With the sunshade closed, insert lengths of material into the
welting channels on the roof struts from the bottom, on both sides
at the same time, and slide them up (1). With square or rectangular
sunshades, the number on the outside of the material must corre-
spond to the number of the roof strut (2).
• (Fig. 8) Align the welting profile with the end of the channel (3) and
screw the welting screw into the centre of the welting (4).
• (Fig. 9) Put on the top plate (5).
• Then, align the lower end of the profile in the same way and insert
screws.
• Lock with the strut cap (6).
• Remove any obstacles to opening. Open the sunshade carefully and
check that the covering is sitting correctly.
4. DISMANTLING Preparation
(2 adults are required):
1 person to stand on a stable ladder or platform
1 person on the ground to assist
4.1 Dismantling the Cover
• Remove the top plate (fig. 10).
• Screw out the top welting screw (fig. 11).
• Pull out the strut cap (fig. 12).
• Pull out each length of material individually after unscrewing the
bottom welting screws (fig. 12). Stack the lengths of material on top
of each other in a bundle and loosely roll together to protect them
from dirt. Be careful not to bend the welting profiles.
• Unscrew the sunshade struts’ axle supports from the sliding- und
crown-shaped discs (fig. 13).
• Lower the telescopic tube.
2
3
5
1
2
1
6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
