8
Vertical LED Task Lights for Recessed Mounted
4” Deep or 6” Deep Mirrored Cabinet
FOR INSTALLATION OF A RECESSED MOUNTED CAB-
INET BE SURE TO TURN OFF THE POWER AT THE
SERVICE PANEL BEFORE WORKING ON WIRING.
1. Adding the Vertical LED Task Lights to any cabinet in-
creases the width of the framed Rough Opening by 4 3/4”
(2 3/8” for each fixture on the left and right). Frame
according to the Cabinet Manual with this additional
dimension. (See page 5 for the modified Rough Opening
Dimensions.)
2. Install the rough service wiring from the switch as
located in the wall near the final cabinet position. Rough
wire from the Switch Box to the general area for each light
at the measured and marked location for the cabinet instal-
lation. Drill the wire access hole (1 1/2” dia) to align with
the selected access hole in the fixture.
Assemble the Cabinet with the Light Fixtures:
3. To install the light fixture on the cabinet and to connect
the power supply you must gain access to the interior of
the light fixture. Open the fixture with these steps:
-- Remove Top & Bottom plates with the two screws
located in the rectangular
part of the plates.
-- Remove the acrylic
diffuser by squeezing from
the narrow side and
pivoting it away from the
fixture.
-- Unscrew the three
flathead stainless screws holding the
outer Mounting LED Panel, the panel
with the mounted LED strips . Pivot the
outer Mounting Panel to the outside
and
disconnect the plug that connects the
12V LED Driver box to the light strips
and set the LED Mounting Panel
assembly aside.
4. Holding the inner wall panel of the fixture against the outer wall of
the cabinet align the two factory installed connecting brackets with the
proper holes in the cabinet wall and attach this part of the light fixture
with the four (4) #10-32 screws supplied. (Reminder: the 30” and 36”
Vertical lights come marked as left and right. Keep the parts for each
light fixture separate until reassembly.
Repeat these steps for the opposite light fixture.
BLACK
WHITE
12V LED DRIVER
GREEN
L
G
N
TERMINAL
BLOCK
SERVICE WIRE
Detail #1
SECTION VIEW OF A 4” RECESSED CABINET WITH VERTICAL LED TASK LIGHTS.
Squeeze
Diffuser and
Pivot away
from
Narrow side
Remove top
and
bottom Plates
NOTE: TAKE CARE IN HANDLING AND
INSTALLING TO AVOID DAMAGE TO MIRRORS.
ALWAYS PLACE THE MIRRORED CABINET ON A
PADDED SURFACE TO PROTECT GLASS.
